|
Automatically shuts down system if an overflow condition occurs.
A ruptured pipe or broken sprinkler left undetected can result in substantial damage. Plants and ground cover can be flooded, and slopes can be eroded. The Flow-Clik™ can help identify a break before any damage can occur. The Flow-Clik can be programmed at a specified level of flow; once that level is exceeded, the electrical circuit is broken and the valves are shut off. The amount of water loss in the event of high external leakage is substantially reduced.
Flow-Clik™ MODELS
FCT Sensor Bodies:
FCT 100 (4.8" H x 2.3" W x 4.5" L) Sch. 40
FCT 150 (5.4" H x 2.3" W x 4.6" L) Sch. 40
FCT 200 (5.9" H x 2.7" W x 4.7" L) Sch. 40
FCT 300 (7.0" H x 4.0" W x 6.2" L) Sch. 40
FCT 400 (6.5" H x 5" W x 6.5" L) Sch. 40
Interface Panel (Flow-Clik Only):
(4.5" H x 5.5" W x 1.5" D) Not required for Flow-Clik IMMS
OPERATING SPECIFICATIONS
• Temperature: 0-150 degrees F
• Pressures: up to 200 PSI
• Humidity: up to 100%
FLOW-CLIK INTERFACE PANEL
36" leads provided for easy wiring to controller
(2 wires to controller 24VAC terminals and 2 wires to sensor and terminals)
ELECTRICAL SPECIFICATIONS
• Current draw: @24VAC .025 Amps
• Switching current: 2.0 Amps
• Maximum distance between interface panel and sensor = 1000 ft.
(18 gauge minimum wire size) 2 wires required for Flow-Clik Sensor,
4 wires required for Flow-Clik IMMS Sensor to IMMS Interface
FLOW-CLIK ADDITIONAL FEATURES
• Programmable start up delay (0 to 300 Seconds)
• Programmable interrupt period (2 to 60 Minutes)
• System status indicator light
• One button system calibration to highest flow zone
 Flow Clik Brochure
(PDF: 97 KB)
Flow Clik Owner's Manual
(PDF: 97 KB) |
